Items 1 - 7 of 7
…with our 3135EC undermount solution, this kit includes one pair of bottom inset bracket assemblies in a zinc finish, adding ease and precision to alternative frames and mounting styles. For thorough installation, a rear face frame bracket (4180-0656-XE) is also required. Along with both brackets, this single kit also comes with two each #8-32 flat head screws, and an installation guide inside a polybag. Cabinet mounting screws are not included in this kit and must be purchased separately.
Bottom mount + top-of-mind. Compatible with the 3135EC Eclipse Undermount solution, this bracket kit supplies the tools and instructions for installing the 3135EC for fixtures and frames that require a bottom mount technique. Including four bottom-mount brackets with a zinc finish, this kit also contains eight #8 32 + ¼" self-tapping screws and an installation guide. One RoHS-compliant kit accommodates one pair of 3135EC slides, with bulk orders also available.
…Lightweight + Low-maintenance. One meter longer than its counterpart (FG115-0100T), this rail is made from the same hard anodized aluminum that serves as the basis for the FG115 Linear Motion Guide's fluid movement and tough outer coating that requires minimal upkeep. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
Made to accompany our 3135EC, this bracket kit aids in easy-access installation for rear-facing frames and fixtures in need of concealed hardware. Including two rear brackets with a clear zinc finish, this kit also contains six #8 x ⅝” screws and an installation guide--all inside a polybag. This kit is also RoHS-compliant and available for bulk orders.
Inset installation made simpler! Engineered for use with our 3135EC Eclipse Undermount solution, this bracket kit assists with implementing a flush inset drawer front in need of concealed hardware. Complete with 2 RoHS-compliant inset assemblies with a zinc finish, two #8 32 flat head screws, and an installation guide--all inside a polybag--this kit is also available for bulk orders, fulfilling projects of any scale.
…Detail Page Lightweight material packed with maximum endurance. Engineered with pre-drilled holes and specially designed to accommodate side-, flat-, and vertical-mounting techniques, this aluminum rail serves as the foundation for the FG115 Linear Friction Guide. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
…a convenient lock-out to hold chassis open for extended periods. * Supports loads up to 200 lbs. * Tested chassis width at 16” * For additional technical information see below Including guide pins that provide stability and cable management that allows for direct attachment to motion hardware, the 3507 is also engineered with our One Motion Insertion that simplifies installation and reassembly of heavier loads and chassis. Increase your efficiency and up-time with this action-packed solution.
Items 1 - 7 of 7