Bottom mount + top-of-mind. Compatible with the 3135EC Eclipse Undermount solution, this bracket kit supplies the tools and instructions for installing the 3135EC for fixtures and frames that require a bottom mount technique. Including four bottom-mount brackets with a zinc finish, this kit also contains eight #8 32 + ¼" self-tapping screws and an installation guide. One RoHS-compliant kit accommodates one pair of 3135EC slides, with bulk orders also available.
…200 is a fantastic addition to any computer workstation. * ¾-extension * Unit width at 29.6” * For additional technical information see below Complete with adjustable mounting brackets that allow you to mount the keyboard tray inboard or outboard, installation is made simple yet versatile, and slides remain entirely concealed in the finished design. If that's not enough, the hold-in and hold-out detents keep your keyboard tray solidly positioned for maximum productivity and unfailing function.
A rear bracket for installing the 3732 into face frame cabinets.
Rear bracket for installing 3832 Touch-Release slides into face frame cabinets. Each kit includes: * Compatible with 3832ETR and 3832EHDTR
Rear bracket for face frame installation, compatible with 3832EC
Return to 116RC Product Detail Page Extra smooth movement and proven endurance. Specially engineered for the 116RC Sliding Door Hardware Kit, this door bracket kit helps protect your linear track system’s carriages when a damper (CB0116-DAMP) is installed to cushion a fixture’s end of travel.
Return to 116RC Product Detail Page Extra protection + Quality assurance. Engineered specifically for the 116RC model, this recycling bracket protects the carriages on your linear track system when a damper (CB0116-DAMP) is installed to cushion a fixture's end of travel. One recycling bracket is needed for each recirculating ball carriage.
Compatible with the 3160EC Eclipse Undermount slide for drawers up to 42” wide, this drawer stabilizer kit provides strength and stability for wider drawers while also eliminating racking, side-to-side movement, and hardware failure. Comprised of two stabilizer carrier strips, the installer attaches the included connector clips and pulley bracket for a trouble-free process and extra-durable finished fixture.
…Detail Page Lightweight material packed with maximum endurance. Engineered with pre-drilled holes and specially designed to accommodate side-, flat-, and vertical-mounting techniques, this aluminum rail serves as the foundation for the FG115 Linear Friction Guide. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
…Lightweight + Low-maintenance. One meter longer than its counterpart (FG115-0100T), this rail is made from the same hard anodized aluminum that serves as the basis for the FG115 Linear Motion Guide's fluid movement and tough outer coating that requires minimal upkeep. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
…¾” Drill Extension: Paired with the 3/32” Drill Bit, this extension improves access when pre-drilling disconnect lever holes at the required 10-degree angle. * #2 x 4” Phillips Point Screwdriver Bit: The length on this bit gives installers better access when installing the screws for the disconnect levers. * ¼” Brad Point Drill Bit: This bit is designed for drilling the hook holes in the back of the drawer. If used with the Accuride Drilling Jig, no measuring is required. * ¼” Stop Collar: Used…
Return to 116RC Product Detail Page Ensuring ease from start to finish. Engineered specifically for the 116RC model, these aluminum end stops ensure that your linear track system ends its length of travel safely and soundly--without slamming or rattling shut. Each order comes with two end stops crafted from corrosion-resistant aluminum and two screws for a breezy installation.