Items 1 - 9 of 9
Return to 116RC Product Detail Page Finishing touches for sliding door hardware. Engineered for the 116RC Door Hardware Kit, these fascia end caps stabilize the anodized aluminum fascia board on its support beam, specifically for use with track systems on sliding doors. Each order comes with two fascia end caps and eight screws for a thorough installation and robust solution.
Return to 116RC Product Detail Page Extra smooth movement and proven endurance. Specially engineered for the 116RC Sliding Door Hardware Kit, this door bracket kit helps protect your linear track system’s carriages when a damper (CB0116-DAMP) is installed to cushion a fixture’s end of travel.
Return to 116RC Product Detail Page Extra protection + Quality assurance. Engineered specifically for the 116RC model, this recycling bracket protects the carriages on your linear track system when a damper (CB0116-DAMP) is installed to cushion a fixture’s end of travel. One recycling bracket is needed for each recirculating ball carriage.
…Detail Page Lightweight material packed with maximum endurance. Engineered with pre-drilled holes and specially designed to accommodate side-, flat-, and vertical-mounting techniques, this aluminum rail serves as the foundation for the FG115 Linear Friction Guide. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
…Lightweight + Low-maintenance. One meter longer than its counterpart (FG115-0100T), this rail is made from the same hard anodized aluminum that serves as the basis for the FG115 Linear Motion Guide’s fluid movement and tough outer coating that requires minimal upkeep. Self-lubricated for seamless motion, FG115 rails can be cut to a determined length or butted together for an extended span of travel. For optimal performance and longevity, utilize all fixing holes when installing this hardware.
Return to 116RC Product Detail Page The sum of its parts. A component within the Sliding Door Hardware Kit for the 116RC Heavy-Duty Linear Track System, this 142” fascia is crafted from anodized aluminum and clips onto its support beam (AL0116-SUPPRC) for a sleek, completed design. For extra easy-access, an installer can lift and hook the fascia open to reach the track and fittings responsible for linear motion.
Return to 116RC Product Detail Page Ensuring ease from start to finish. Engineered specifically for the 116RC model, these aluminum end stops ensure that your linear track system ends its length of travel safely and soundly--without slamming or rattling shut. Each order comes with two end stops crafted from corrosion-resistant aluminum and two screws for a breezy installation.
- SS0116-CASSRC SS0116-CASSRC 116RC Cassette with Stainless Steel Bearings$192.48
Return to 116RC Product Detail Report Available as a single component or within a kit for our 116RC Linear Track System, this cassette model is crafted with stainless steel ball bearings for added strength, providing unerring endurance to your design’s overall function. Easy-to-install and available for flat- or side-mounting, this stainless steel ball bearing carriage adds heavy-duty seamless, smooth motion to your aluminum track hardware.
Stainless steel hardware with an easy-going side. Specially engineered with corrosion-resistant stainless steel and easy-install, L-shaped brackets with locator pins for a seamless disconnect, the SS5322 is the ideal solution for fixtures in commercial kitchens and industrial or outdoor cabinetry exposed to the elements. * Supports loads up to 265 lbs. * For drawers up to 18” wide * For additional technical information see below Equipped with a handy hold-in detent that eliminates any chance of…
Items 1 - 9 of 9